Description

Project boat for sale.62 foot in length ex hire boat built in Bromsgrove. Cabin stripped out for rebuild. All hull work has been done following survey report hull has been over plated to restore hull thickness as per survey report. Engine runs, but requires service. Engine room requires refurbishment and all electrics require re- working to suit new cabin installation. Plumbing requires installing again as per new cabin refit. New floor timbers on board ready to be replaced. Front window broken and requires new glass panes fitting. Engine room electrics require sorting out to current BSS standards once engine room has been refurbed. New batteries required combined with new battery tray to support leisure bank and start battery.

Specifications

Accommodation

Cabin has been completely stripped out to allow interior steel work to be treated and painted, this includes being able to lift the floors to remove ballast to be able to paint base plate. Some of this work has been started but not completed.
Plating or replacement of rear locker required. Rear aft deck requires replacement due to corrosion and combined with install of new water drain channels.

Construction

Steel construction, semi trad design. Based on hull base plate thickness originally of 10mm, hull sides 6mm cabin sides 4mm. Please note the following work was carried out on the hull in November 2022. Boat craned out of the water for full shot blast to remove all previous coatings from base plate and sides. Following on from a full hull survey, all repair recommendations were carried out. This involved over plating to hull sides from chine up to above waterline to "D" bar, this was carried out from the turn of the bow back to the rear stem post. Restoring sacrificial chine following over plating. Plating and welding around rear stem post. Re plating weed hatch fitting new baffle plate. Re-blacking hull side plates and base plate in twin pack blacking and application of sacrificial anodes to bow and stern and possibly side plates to offer full anode protection.

Equipment

None currently beyond current mooring ropes and what is currently on the boat. New rear semi trad area cover fitted.

Navigation Equipment

Engine(s)

4 cylinder Kubota marine diesel approximately 40 hp engine cooled by external skin tank. Engine room requires complete rust treatment and a full repaint ideally with the engine removed for full access.

Sails & Spars

Safety Equipment

Full exterior of the boat requires a complete repaint as currently only painted in peeling primer/undercoat.

Location Map